Rio NAPE Manual page 5

Plug the USB Charging Cable into the USB 'In' port on the Control Unit
and then into a USB port. The Battery Level indicator will flash whilst
charging. The Battery Level indicator will show 4 bars when fully charged.
To fully charge takes up to 4 hours.
Note: The Handpiece is disabled when charging.
1 FITTING THE SIDE HOLDER
The Side Holder can be inserted and clipped into place on the left or
right side of the Control Unit.
2 FITTING A TOOL
1. Make sure the Tool Lock is in the unlocked position, remove the
Blank Pin and store safely.
2. Place your chosen tool into the Collet opening and push in firmly.
3. Apply the Tool Lock.
To remove:
1. Turn the lock to the unlocked position and pull the tool out.
Important info: Always replace the Blank Pin into the Handpiece when
the unit isn't in use. This keeps the Collet straight and protected. If the
Collet is damaged, inserted tools will not spin straight and may cause
injury.
CHARGING
5