Advertisement
Quick Links
To complete the assembly of your Florence Stand
you will need the following tools:
A No 2 Phillips Head Screwdriver
A No 4 Allen Key (Hex)
Within your delivery you'll find the following parts and hardware.
Parts:
2
Vertical Frame
Mid x 1
Rear Brace Short x2
Hardware:
a
Self-tapping screws
13mm long x12
3
Vertical Frame
Vertical Frame
Side L x1
6
b
Machine Screws
20 mm long x13
FLORENCE 8 BOX STAND
AS SE M B LY INS TRU C TIO NS
4
Side R x1
Rear Brace Long x1
Screw-In Feet x4
1/1
1
Timber Top x1
5
Base Plate x2
7
c
Advertisement
Summary of Contents for SAGITINE FLORENCE 8 BOX STAND
- Page 1 FLORENCE 8 BOX STAND AS SE M B LY INS TRU C TIO NS To complete the assembly of your Florence Stand you will need the following tools: A No 2 Phillips Head Screwdriver A No 4 Allen Key (Hex) Within your delivery you’ll find the following parts and hardware.
- Page 2 Step 1 Place a clean towel or blanket on the ground first to place the Timber Top on to avoid scratching or marking the timber. Place the Timber Top upside down on top of the towel or blanket on the ground so that the holes are showing.
- Page 3 Step 2 Attach both Vertical Frames - Side L and R to the Timber Top as shown using 6x Self Tapping screws. Note: Ensure all Frames are in line with the rear edge of the Timber Top. Rear Fasten the Frame to the Timber Top with the 6x Self Tapping screws.
- Page 4 Step 3 Place the Base Plates across the three Vertical Frames as shown, aligning the holes with the Threaded Inserts. Fasten the Base Plates to the Vertical Frames with 6x Machine Screws and 4x Screw-In Feet. Larger hole this side...
- Page 5 Install the Rear Braces by aligning holes in the brace with the Threaded Inserts in the Vertical Frames. Fasten with 7x Machine Screws. Flip your Florence Stand so that the Timber Top is upright, insert your 8 Milan Boxes and enjoy your new Sagitine piece. Sagitine – Storage you want to see www.sagitine.com...