Rear Panel; Installation Instruction - SOYO AVRO 3002 User Manual

2.1.2 Rear Panel

Item Connector
1 12V DC
RESET
2
(Reboot)
3 WAN
Local
4
(1-4)
5 Phone

2.1.3. Installation Instruction

1. Connecting a Phone set: Connect phone set directly to one of
the two Phone ports on the AVRO 3002
2. Connecting a Computer: Connect computers directly to the
AVRO 3002 on ports 1-4 of the LAN ports. If you have more than
4 computers to plug in, connect a hub or a switch (using its
uplink port) and connect additional computers to that device.
3. Connecting a Cable Modem or DSL Modem: Connect your
Cable or DSL modem to the WAN port on the rear panel.
4. Power: Plug the power cord into the power jack.
5. The device will boot up at this moment. Make sure the LED in
front panel light up correctly.
7
SOYO AVRO3002 Ethernet Router Manual
Function
Power connector.
Reset button. Press for one second to reset the device or
press for 5 seconds to reset to the factory default.
Connect to Cable or ADSL Modem
4 port (10/100Mbps) RJ-45 connector, connect to PC
or local switch/hub.
Connect to Phone set (or Connect to PBX CO Line)