Table of Contents
Advertisement
17 WARRANTY
Icoms Detections warrants its hardware products to be free from defects in workmanship and materials, under normal use
and service, for a period of two (2) years from the date of despatch from Icoms Detections premises, except for the batteries
for which a warranty period of six (6) months applies.
If a product does not operate as warranted during the applicable warranty period, Icoms Detections shall, at its option,
either repair the defective unit, either deliver to the buyer an equivalent product or part to replace the defective item. All
products that are replaced become property of Icoms Detections.
The defective product must be returned to Icoms Detections within the applicable warranty period. The defective product
must be shipped back to Icoms Detections pre-paid, insured and wrapped in the original or similar shipping package to
ensure that it will not be damaged during transportation, and must be accompanied by appropriate paperwork (ask first for a
Return Material Authorisation number) detailing the nature of the defect experienced.
Icoms shall be under no liability in respect of any defect arising from normal wear and tear, wilful damage, negligence,
damage due to inappropriate packaging, abnormal working conditions, failure to follow Icoms Detections instructions
(whether oral or in writing), misuse, improper installation, alteration or repair without Icoms Detections approval.
18 DECOMMISSIONING
We encourage customers to send back decommissioned equipment to the manufacturer for recycling. To differentiate
between equipment to be recycled and equipment to be repaired, please inform your reseller or the manufacturer about the
decommissioned equipment.
Icoms Detections will take care of the recycling for a sustainable end-of-life of the product.
19 FURTHER INFORMATION
19.1 L
EGAL NOTIFICATION
Hereby, Icoms Detections declares that the TMA range is in compliance with the requirements and other relevant provisions
of Directive 2014/53/EC.
The Lidar is classified EN/IEC 60825-1 2014.
The Gemalto modem is in compliance with following requirements:
•
RED Directive 2014/53/EU.
RoHS 2 2011/65/EC
•
WEEE 2003/108/EC
•
•
FCC ID: QIPEHS6
IC: 7830A-EHS6
•
19.2 V
ERSION
Issue n°
Date
V1
25 June, 2018
V1,2
25 June, 2019
V2
04 September, 2019
V3.1
18 may, 2020
V3.2
07 October, 2020
V3.3
19 October, 2020
V3.4
03 December, 2020
V3.5
26 April, 2020
V3.5.1
10 November 2021
V3.5.2
April 5, 2022
V3.5.3
October 19, 2022
V3.6.0
January 5, 2023
V3,6,1
January 16, 2023
V3.6.2
May 5
th
, 2023
V3,6,3
July 28, 2023
19.3 T
:
HE MANUFACTURER
Author
Comment
CBA
First generic version
CBA/PSP
Gemalto modem, configuration
CBA
New TMA-3B3 housing
CBA
New sketches (housing vers. 2) – vandal-proof additional housing
EVDB
Update on Command Line Interface
EVDB
Update on Command Line Interface
EVDB
Max speed and ITC messages
EVDB
Software version 1.1.5
CBA
Height & figure nr
EVDB
Change in connector cable impacting wire colours
EVDB
Added "Decommissioning" section
EVDB
Screenshots of new software v1.2.2 – SD card reader
CBA
RS-232 communication
EVDB
SD card data collection
CBA
Installation height
Icoms Detections S.A.
Avenue Albert Einstein 11/B ▪ B-1348 Louvain-la-Neuve ▪ BELGIUM
Tel.: +32 (0) 10 45 41 02 ▪ Fax: +32 (0) 10 45 04 61
info@icomsdetections.com ▪ www.icomsdetections.com
22
Advertisement
Table of Contents
