Download Print this page
Rasland MCB-DK001 Installation Manual

Rasland MCB-DK001 Installation Manual

Bathroom carbinet

Advertisement

Quick Links

1
WARNING
1.1
Do not throw any hard objects on to the ceramic.
1.2
Do not scrub by using hard or rough objects on the ceramic or cabinet.
2
MAINTENANCE
2.1
Do not leave stain on the cabinet or ceramic basin for long time.
2.2
ผลิ ต ภั ณ ฑ์
Please use normal water to clean the basin and the cabinet and
wipe to dry after each use.
2.3
To maintain the cabinet in a good condition, do not put the cabinet
soak with water. Do put in a dry place.
3
INSTALLATION PREPARATION
3.1
Be careful when moving the heavy objects. Please do ask for assistant.
3.2
The wall must be flat and built in vertically balance. The wall must be
strong and thick enough to hold the cabinet and ceramic basin.
55-60
3.3
The standard height of the drain hole should be around 50-60 cms.
from the ground.
3.4
The standard height of the basin should be around 85-90 cms.
from the ground.
.
85-90
.
BATHROOM CARBINET
INSTALLATION GUIDE
To install your bathroom products
please ensure you read the following
instructions below.
MCB
DK001
W
X
mm
mm
16
834
TOOLS REQUIRED (NOT PROVIDED)
!
This product is heavy and may require two people to install.
CUSTOMER
SERVICE
Illustrations may
not reflect every
exact model
@Rasland
080-075-8668
Prior to installation
It Is important that the product is unpacked
and inspected for any damage, defects and
that the product supplied is correct. if any
of the above is apparent, do not proceed
with this installation, and immediately
contact the store of purchase.
PROVIDED FITTING IN BATHROOM CABINET SET

Advertisement

loading

Summary of Contents for Rasland MCB-DK001

  • Page 1 Do not scrub by using hard or rough objects on the ceramic or cabinet. To install your bathroom products please ensure you read the following instructions below. @Rasland MAINTENANCE 080-075-8668 DK001 Do not leave stain on the cabinet or ceramic basin for long time.
  • Page 2 INSTALLATION STEPS STEP STEP Measure and drill holes Place the ceramic basin on the cabinet and adjust the basin in the right position Scale for the balance of the cabinet Make a mark Plastic socket Drill holes on the wall Put the plastic socket into the drilled holes STEP...