Advertisement
SPECIFICATIONS
Model: SC20C
20 Farad Hybrid Super Capacitor (Carbon And Electronic
Capacitor) With Blue Digital Voltage Display, Blue Flash LED
Capacitance ............................................ 20,000,000 micro farad
Working Voltage ........................................... 16DC
Surge Voltage ................................................ 18DC
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25 °C
Capacitance Tolerance--------------------------- ± 10%
Model: SC40C
40 Farad Hybrid Super Capacitor (Carbon And Electronic
Capacitor) With Blue Digital Voltage Display, Blue Flash LED
Capacitance ............................................ 40,000,000 micro farad
Working Voltage ........................................... 16DC
Surge Voltage ................................................ 18DC
E. S. R. (Equivalent Series Resistance)........... 0.0015 ohm @120hz/25 °C
Capacitance Tolerance.................................... ± 10%
DETAILED FEATURES:
a)
4 digits hi-end blue light display DC voltage meter that can measure 0.1
DCV range.
b)
Reverse pole connecting PCB buzz warning function. If the capacitor is
connected incorrectly by reversing the positive and negative wires
during the installation process the PCB will issue a 45 second noise to
warn you.
c)
Hi-end platinum plated 100% brass solid parts and chrome plated metal
cover
d)
Over voltage limit and low battery voltage limit warning. When the
system voltage peeks over 17 DCV or LESS than 10 DCV. The buzzer
on the PCB will issue an audible noise warning.
e)
Multiple small capacitance capacitors linked to provide the lowest inner
E.S.R. and largest moment discharge power.
1
Advertisement
Table of Contents
Related Manuals for Soundstream SC20C
Summary of Contents for Soundstream SC20C
- Page 1 Over voltage limit and low battery voltage limit warning. When the system voltage peeks over 17 DCV or LESS than 10 DCV. The buzzer on the PCB will issue an audible noise warning. Multiple small capacitance capacitors linked to provide the lowest inner E.S.R. and largest moment discharge power.
- Page 2 To Charge the capacitor: Make Capacitor positive terminal connections with amplifier and tighten the bolt. Do not over-tighten the bolts! Caution: Stripped terminals are not covered under the capacitor's warranty. Connect the ground cable with battery, amplifier, then refer to the attached drawing.
- Page 3 INSTALLATION AND MOUNTING: You must first attach the mounting tabs to the capacitor before mounting it. Use the supplied hardware shown in the picture to the right. Notice the small mounting screw hole in the capacitor chassis. CHARGING THE CAPACITOR AND WIRING: The capacitor must be charged before connecting the Power and Ground cables to the capacitor.
- Page 4 To Discharge the capacitor: With battery power disconnected, place the light bulb or resistor across the capacitor's positive and negative terminals until light goes out or for three minutes if using a resistor. Multiple Capacitor Wiring Diagram: REMOTE REMOTE THIS POWER CAPACITOR MAY EXPLODE AND CAUSE SERIOUS INJURY IF ABUSED OR CONNECTED IMPROPERLY.
Need help?
Do you have a question about the SC20C and is the answer not in the manual?
Questions and answers