Operating Elements And Connections; Front Panel - Omnitronic XDP-1502 Product Manual

4 Operating Elements and Connections

Front panel

No. Element
1 CD drive
2 Infrared sensor for the
remote control
3 OPEN/CLOSE button
4 JOG MODE button
5 CD/USB/SD button
6 VFD display
7 IN button
8 OUT button
9 RELOOP button
10 ON/OFF HOLD button
11 Pitch slide control
12 Memory card slot
13 USB port
14 POWER switch
15 Jogdial
16 BPM TAP button
17 TRACK/FOLDER
press control
1
13
12
Function
For inserting a CD
When actuating a button, always direct the remote control towards the
sensor. There must be no obstacles between the remote control and the
sensor. If the range of the remote control decreases, the batteries are
probably exhausted and must be replaced.
Ejects and retracts the CD; while playing a CD, the CD drive is locked
against unintentional opening.
Sets the operating mode for the jogdial: pitch bend (LED off), search (LED
lights) and scratch (LED flashes)
Switches between CD, USB and SD operation
Shows all functions of the unit and information of the data carriers such as
bargraph, title number, pitch value, single playback mode, loops, play or pause,
repeat settings, title and folder names and elapsed, remain or total remain time
(audio CD only) indicated in minutes, seconds and frames (1/75 second)
Sets the starting point of a loop (corresponding LED lights red)
Sets the end point of a continuous loop which is instantly started (IN and
OUT LEDs will be flashing). The loop will continue to play until the OUT
button is pressed once again; then the IN and OUT LEDs will stop flashing
but will remain on to indicate that a loop has been memorized and is ready
to be engaged. To program another loop, simply redefine the starting and
the end point with the IN and OUT buttons. To set the loop points precisely
to 1 frame (1/75 second), enter pause mode and use the jogdial (set to
search mode) to go to the exact spot
Reengages the loop; the IN and OUT LEDs will be flashing again
Selects the setting range for the pitch slider: 4 %, 8 % or 16 %. A long press
deactivates the pitch control (indication - -)
Sets the playback speed up to ±16 %; the pitch percentage is indicated in
the display
For inserting an SD(HC) or MMC card
For inserting a USB storage medium
Turns the unit on (LED indicator lights) and off
As default setting the jogdial can be used for pitch bend, i.e. a temporary change
of speed. In search mode the jogdial can be used for fast forward and reverse, as
well as for a fine adjustment to cue and loop points. In scratch mode it can be
used for scratch effects. The operating mode is set with the JOG MODE button.
To determine the beats per minute (BPM) for the current title simply tap the
button to the beat of the music until the value is indicated in the display
• Turn the control to browse titles, and then press it to select the desired
title; title number and title name are indicated in the display
• For selecting folders, first press the control, and then turn it to browse the
folders. Press the control again to select the desired folder. Afterwards,
the unit switches back to the title selection mode.
2 3 4 5
14 15 16
.
12 • EN
6 7 8 9 10 10 11
17 18 19 20 21 22 23 24