Subscribe to Our Youtube Channel
Related Manuals for BASSFACE GT Audio GT-SW10/4
Summary of Contents for BASSFACE GT Audio GT-SW10/4
- Page 1 GT Audio GT-SW10/4 10'' 2X4Ohm DVC 200w RMS Subwoofer Driver- Sealed/Ported Enclosure Instruction manual...
- Page 2 Thank you for choosing Bassface. From the simplest connector to our top of the range amplifier - every element of these products has been designed to give you the best possible performance for your money. Please take the time to read these instructions carefully as they contain useful and important information.
- Page 3 aiming to give the customer a good indication of the level of power that the speaker will be able to cope with as a maximum value, when installed into a closed field environment (a car!) using a suitably designed bass enclosure and running an intelligently set subsonic filter and low pass crossover and when fed from an amplifier that is outputting clean, crisp power (not a load of distortion!).
- Page 4 bass you MUST run the woofers in separate air chambers. Additionally, if you are running a complex setup of multiple amplifiers driving multiple coils or speakers you MUST meter the amplifiers at various levels to ensure the voltages at the coils are equal. Imbalance in this area will at best cost you SPL and at worst will damage your equipment.
Need help?
Do you have a question about the GT Audio GT-SW10/4 and is the answer not in the manual?
Questions and answers