Hover-1 ALPHA CARGO Operation Manual page 18

CHARGING YOUR ALPHA CARGO
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V-240V; 50 Hz/60 Hz).
• Align and connect the 1-pin charging cable into the charging port
of the Alpha Cargo (DO NOT FORCE OR BEND THE CHARGING
CABLE AS IT MAY CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to
red, indicating that your E-Scooter is now being charged.
• When the red indicator light on your charger changes to green,
your E-Scooter is fully charged.
• After fully charging your E-Scooter, unplug the charger from your
device and from the wall outlet.
• If the E-Scooter is not used for an extended period of time, you may
need to recharge the battery every 2 months to maintain the battery
life.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
INSTALL THE HANDLEBARS
Connect the unattached wiring and insert it into the steering column.
Insert the handlebar assembly into the steering colum. Insert 4 bolts
into the steering column and tighten them completely. Ensure the
handlebar assembly is secure.
INSTALL THE FRONT TIRE
Use the wrench to remove the lugnut and washers from one side of
the front fork. Pull the metal rod through the other end of the tire and
remove the protective piece under it. Align the tire with the holes in
the front fork and attach the drum brake to the side of the tire. Thread
the metal rod through the front fork and tire. Add the washers and lug
nut back onto the other side of the tire. Tighten both sides with the
wrench.
CAUTION
Only use the included charging
cable and charger to charge
your Alpha Cargo. Using any
other charger may damage your
Alpha Cargo.
ASSEMBLY
17