Table of Contents
Advertisement
Copyright © 2014-2019 Retrotec Inc.,
All rights reserved.
This document contains materials protected under International and Federal Copyright Laws. No part of
this book may be reproduced or transmitted in any form or by any means, electronic or mechanical,
including photocopying, recording, or by any information storage and retrieval system without express
written permission from Retrotec Inc.
Retrotec makes no warranties with respect to this documentation and disclaims any implied warranties
of merchantability, quality, or fitness for any particular purpose. The information in this document is
subject to change without notice. Retrotec reserves the right to make revisions to this publication
without obligation to notify any person or entity of any such changes.
DucTester, Infiltrometer, FanTestic are Trademarks of Retrotec Inc. Other trademarks or brand names
mentioned herein are trademarks or registered trademarks of their respective owners.
Retrotec test fans, blower door systems, duct testing systems and gauges have been calibrated in our laboratory
which is accredited by the ANSI-ASQ National Accreditation Board to meet requirements of international standard
ISO/IEC 17025:2005. All pressure and flow devices used in the calibration are traceable to the National Institute of
Standards and Technology and themselves have ISO 17025 accreditation.
Retrotec equipment and software complies with the following standards:
ASTM E779-10, ASTM E-1554, ATTMA TSL1, ATTMA TSL2, CGSB 149.10, DW/143, Energy Star, EN12237, EN13829,
EN15004, FD E51-767, ISO 9972-2015, ISO 14520-2006, NEN2686, NFPA 2001-2015, RESNET, SMACNA-2002, All
USA State Energy Codes, Title 24 and USACE Protocol.
Custom calibration available upon request
Page 3 of 58
©Retrotec Inc. 2015
Advertisement
Table of Contents
