Installation
values in the "Technical specifications"
table. The manufacturer shall not be liable
for any damages that will arise when the
product is used without grounding in
accordance with the local regulations.
Connection must comply with national
•
regulations.
Power cable plug must be within easy
•
reach after installation.
B
Unplug the product after the
washing programme is over.
The voltage and allowed fuse or
•
breaker protection are specified in
the "Technical specifications" section.
If the current value of the fuse or
breaker in the house is less than 16
Amps, have a qualified electrician
install a 16 Amp fuse.
The specified voltage must be equal to
•
your mains voltage.
Do not make connections via
•
extension cables or multi-plugs.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
B
If your dishwasher is equipped
with internal illumination, lamp
should only be replaced by the
Authorised Service Agent in
case of failures that may occur
on the lamp.
B
If the product has a failure, it
should not be operated unless
it is repaired by the Authorised
Service Agent! There is the risk
of electric shock!
Initial use
Before starting to use the product, make
sure that all preparations are made
Dishwasher / User's Manual
in accordance with the instructions in
sections "Important safety instructions" and
"Installation".
To prepare the product to do the dishes,
•
perform first operation in the shortest
programme with detergent while the
machine is empty.
A
There might be a small amount
of water left in the product
after factory quality control
tests. This has no harm on the
product.
11 / 42 EN