Straight tachometer cable for ams2140, 8-pin m12 connector to male bnc connector. 4 feet long. not compatible with the model 2130. can be used with the battery pack of the ams 404 or for tach signals from protection monitoring panels (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with red heat shrink (1") overlapped by blue heat shrink (1/2”) on both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with green heat shrink (1") overlapped by white heat shrink (1/2”) on both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded with 2-socket, molded composite connector on one end and bnc plug on the other end) with green heat shrink (1") applied to both ends. configurable length (6 pages)
Polyurethane cable, 2-conductor twisted pair w/drain, shielded, 2-socket ms3106 connector w/strain relief (meets mil-c-5015) on one end (ap), 5-socket field-installable m12 connector with pinout for beckoff el3632 daq on other end (sj) (6 pages)
Summary of Contents for PCB Piezotronics 023B10
Page 1
***DO NOT SELL, SEE 023A10*** Hardline, mineral insulated, coaxial cable, 10-ft, 10-32 plug to 10-32 jack Installation and Operating Manual For assistance with the operation of this product, contact the PCB Piezotronics, Inc. Toll-free: 716-684-0001 24-hour SensorLine: 716-684-0001 Fax: 716-684-0987 E-mail: info@pcb.com...
Page 2
Assistance is needed to safely operate equipment PCB Piezotronics is an ISO-9001 certified company whose Damage is visible or suspected calibration services are accredited by A2LA to ISO/IEC Equipment fails or malfunctions 17025, with full traceability to SI through N.I.S.T.
Page 3
CAUTION Refers to hazards that could damage the instrument. NOTE Indicates tips, recommendations and important information. The notes simplify processes and contain additional information on particular operating steps. The following symbols may be found on the equipment described in this manual: This symbol on the unit indicates that high voltage may be present.
Page 5
Component Name Hazardous Substances Lead (Pb) Mercury (Hg) Cadmium (Cd) Chromium VI Polybrominated Polybrominated Compounds Biphenyls (PBB) Diphenyl Ethers (Cr(VI)) (PBDE) Housing PCB Board Electrical Connectors Piezoelectric Crystals Epoxy Teflon Electronics Thick Film Substrate Wires Cables Plastic Solder Copper Alloy/Brass This table is prepared in accordance with the provisions of SJ/T 11364.
Page 6
2 DEGREES DWG. NO. (M)023RPGA [-XXXX] CODE 73459 IDENT. NO. LENGTH MAY VARY IN FEET OR METERS DEPENDING ON THE MODEL, 023B10 023B10 CABLE 52681 CABLE IS ALWAYS 10 FEET WITH TOLERANCE LISTED IN TABLE FILLETS AND RADII FILLETS AND RADII...
Need help?
Do you have a question about the 023B10 and is the answer not in the manual?
Questions and answers