Craftsman 152.213361 Owner's Manual page 13

FOROPERATOR S AFETY, keepfingers andaHH foreign
objects outoftheintakeports, T herotating faninside
theMower h ousing is accessibHe through the intake
portsandis hazardous, DonotwearHoose cHothing or
jeweHry, Makecertain thateachintakeportwhichis not
beingusedor attached to a dustcoHHection system is
covered withan intake portcap,
CONNECTING TOOL TO
POWER SOURCE
A separate eHectricaHcircuit shouHd be used for your
tooHs,This circuit shouHd not be Hessthan #14 A, W, G,
wire and shouHd be protected with a 15-amp time Hag
fuse, Have a qualified eHectrician repair or repHace dam-
aged or worn cord immediateHy, Before connecting the
motor to the power Hine, make certain the switch is in
the "OFF" position and be sure that the eHectric current
is of the same characteristics as stamped on the motor
namepHate, AHH Hineconnections shouHd make good con-
tact, Running on HowvoHtage wiHH damage the motor,
DO NOT EXPOSE THE DUST COLLECTOR TO RAmN
OR OPERATE THE MACHmNE mNDAMP LOCATmONS.
Fig. 14
!
A
B
ON/OFF SWITCH
The ON/OFF switch assembHy is Hocated on the side of
the motor, To turn the dust coHHector"ON", move the
switch (A) up to the "ON" position, To turn the dust
coHHector"OFF", move the same switch down to the
"OFF" position, See figure 14,
LOCKING SWITCH JN
THE "OFF" POSiTiON
When the Dust CoHHector i s not in use, the switch key
(B) shouHd be removed so that it cannot be started,
Grasp the switch key and puHH it out of the switch
assembHy, With the switch key removed, the switch
wiHH not operate, However, shouHd the switch key be
removed whiHe the dust coHHectoris running, it can be
turned "OFF", but cannot be restarted without inserting
the switch key, See figure 14,
13