Installation Diagram Of Back Mounting Plate - Naya PNI-RP2710 User Manual

Focus on R&D Stable and reliable
◆ Power wiring: attach the metal latch to the power cable and then connect it to the binding
post.
◆ Attach the metal latch to the networking cable, then press the crystal tip with the mesh
cable clamp and insert it on the networking cable holder, or connect the networking cable
directly to the binding post without pressing the crystal tip.
◆ Locking: After the power cable and network cable should be locked with metal clasp after
connection of the two cables.
◆ Close the outer case: after the above operation, close the upper lid and tighten the screws.
L N
220V binding post
Attention:
The ground wire must
be connected to make
sure normal work.

3.2 Installation diagram of back mounting plate

◆ Install back mounting plate: lock and fix the M5 hex screws with 5# hex wrench.
Networking
Power cable
cable
① ② ③ ④ ⑤ ⑥ ⑦ ⑧
TX+ TX-
White
orange Orange
5
or
RX+ N/C N/C RX- N/C
White White White
Blue Brown
Green
green blue brown
N/C