Table of Contents
Advertisement
8 www.electrolux.com
6.
You may now need to fine-tune the installation by
repeating steps 3, 4 and 5.
7.
When you have the appliance in its final position, it
needs to be stabilised. Wind the stability foot under
the door hinge down to the floor until it just makes
contact with the floor. Lift the front of the appliance
to take the weight off the stability foot, then turn
it half a turn further to ensure firm contact with
the floor. Wind the large height adjusting nut back up
to ensure all the weight is now on the front stability
foot. Wind the large height adjusting nut back up to
ensure all the weight is now on the front stability foot.
8.
Repeat step 7 for the stability foot on the handle
side. Whenever you need to move the appliance, be
sure to wind the feet back up so that the appliance
can roll freely and be sure to reset it when
reinstalling.
front view
9.
Plug your refrigerator straight into its own power
point and never use a double adapter. If you nee d
to roll the refrigerator to get to the plug, remembe r
to raise the stability foot first.
10. Before you put any food in your refrigerator , it's
recommended you leave it on for 2 or 3 hours t o
check it is running properly.
Fitting the handles
For models with 'Pole' handles, the handles are
supplied prepackaged inside your refrigerator and will
require fitting. Refer to the instructions provided in the
pack.
Congratulations! You have successfully installed your
new refrigerator.
USING YOUR REFRIGERATOR
Refrigerators work by transferring heat from the food
inside to the outside air. This operation makes the back
and sides of the refrigerator feel warm or even hot
particularly at start-up and on warm days – this is
normal.
Avoid placing food against the air vents in the
refrigerator as it affects efficient circulation. If the door is
opened frequently, a light frosting will occasionally occur
on the freezer's interior. This is normal and will clear after
a few days. If the freezer door is accidentally kept open,
a heavy frost will coat the inside walls and should be
removed.
Your new refrigerator uses a high-speed compressor,
along with other energy-efficient components, which
may make unusual sounds and be more noticeable at
night and quieter times. These sounds simply indicate
your refrigerator is working how it should. They include:
•
•
stability foot
•
wound down
•
•
Further details can be found in the Troubleshooting Guide.
For bottom mount refrigerators (where freezer is below
the fresh food compartment):
•
LED lighting
Your appliance is fitted with long life LED lighting. In the
unlikely event the LED lights should fail, then the LED
lights should be serviced by the service agent, to avoid a
safety hazard. Refer to the warranty page for contact
details
Compressor running noises;
Air movement noise from the small fan motor;
A gurgling sound, similar to water boiling;
A popping noise, heard during automatic defrosting;
and
A clicking noise, prior to compressor start-up.
IMPORTANT
Ensure all freezer drawers and shelves are pushed
back completely to prevent them from keeping the
door open.
WARNING
Advertisement
Table of Contents
