Siemens TI35A209RW Instruction Manual page 25

The brewing unit cannot be
removed.
The appliance cannot be oper-
ated, LEDs lit up or flashing.
The grinder will not start.
( LED flashes.
( LED lit up despite empty
drip tray - what to do?
' LED lit up despite water
tank being full.
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
The appliance is in demo mode. Hold k button for at least 5 seconds
The appliance is too hot.
The door is not closed properly. Press the door firmly closed.
The appliance is too hot.
Emptying is not detected when
the appliance is off.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Limescale deposits in the water
tank can block up the system.
Trouble shooting en
Switch the appliance on again.
to deactivate demo mode. Remove the
water tank, fill with fresh water and
re-insert.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
When the appliance is switched on,
remove and re-insert the drip tray.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 16
Insert a new water filter.
Clean the water tank, add 0.5 l water
and allow a Siemens descaling tablet
to dissolve completely. Switch the
appliance off and on again so the des-
caling solution is pumped into the sys-
tem. Wait 3 minutes. Repeat the
process.Check whether the appliance
starts. Clean the water tank thoroughly
and start the calc'nClean programme.
~ "Calc'nClean service programme"
on page 22
25