Table of Contents
Advertisement
en-us Troubleshooting
Issue
There are stubborn white coatings
on the dishware, inside the
appliance or on the door.
Tea residue or lipstick marks on
dishware.
There are colored coatings (blue,
yellow, brown) inside the appliance
or on stainless steel dishware that
are difficult or impossible to
remove.
There are colored deposits (yellow,
orange, brown) that are ey to
remove inside the appliance
(mainly at the bottom).
Plastic parts inside the appliance
are discolored.
Plastic parts are discolored.
There are removable streaks on
glasses, glassware with a metallic
appearance and silverware.
34
Cause and troubleshooting
Set the Water softening system to the water hardness and use separate
▶
detergents (name brand, special salt, rinse aid).
Too little detergent is being used.
Increase the amount of detergent used or change Detergent .
▶
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
Dishwashing temperature is too low.
Select a program with a higher dishwashing temperature.
▶
Too little detergent is being used or is unsuitable.
Use a suitable Detergent and follow the manufacturer's instructions for the
▶
amount to be used.
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
The formation of films is due to substances contained in vegetables (cabbage,
celery, potatoes, noodles, etc.) or tap water (manganese).
Clean the appliance.
▶
You can remove coatings with Mechanical cleaning → Page 26 or a machine
cleaning product. It may not always be possible to completely remove coatings
but they are harmless to health.
The formation of films is due to metal components on silver or aluminum dishware.
Clean the appliance.
▶
You can remove coatings with Mechanical cleaning → Page 26 or a machine
cleaning product. It may not always be possible to completely remove coatings
but they are harmless to health.
The formation of films is due to ingredients of food remnants and tap water
(limescale), "soaplike".
Check the setting of the water softening system.
1.
→ "Setting the water softening system", Page 16
Add special salt.
2.
If you are using combined detergents (tabs), activate the water softening system.
3.
Follow the information on detergents.
Plastic parts inside the appliance may become discolored over the life of the
dishwasher.
Discoloration may come about and will not impair functioning of the appliance.
▶
Dishwashing temperature is too low.
Select a program with a higher dishwashing temperature.
▶
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
Amount of rinse aid to be dispensed is set too high.
Set the rinse aid system to a lower setting.
▶
→ "Setting the amount of rinse aid", Page 17
Advertisement
Table of Contents
