Advertisement
Daily Use
Daily Use
Troubleshooting
Caution! Before shooting any trouble, disconnect the power supply. Only a qualified
electrician of competent person must do the trouble shooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes too much
The food is not frozen enough
Heavy build-up of frost on the door
seal
Unusual noises
Side panels are hot
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Possible Cause
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the
appliance runs at SUPER setting
Temperature is not properly adjusted
Door was open for an extended
period
A large quantity of warm food was
placed in the appliance within the last
24 hours
The appliance is near a heat source
Door seal is not air-tight
Appliance is not level
The appliance is touching the wall or
other objects
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall
It's normal. Heat exchange is in the
side panels
21
Solution
Insert mains plug
Check fuse, replace if necessary
Mains
malfunctions
are
corrected by an electrician
Turn the temperature regulator to a
warmer setting temporarily
Please look in the initial Temperature
Setting section
Open the door only as long as
necessary
Turn the temperature regulator to a
colder setting temporarily
Please look in the installation location
section
Carefully warm the leaking sections of
the door seal with a hair dryer (on a
cold setting). At the same time shape
the warmed door seal by hand such
that it sits correctly
Re-adjust the feet
Move the appliance slightly
If
necessary,
carefully
component out of the way
Take gloves to touch side panels if
needed
to
be
bend
the
Advertisement
