Advertisement
6.3.3.
Fit the heater to a new gas bottle as in 5.1.2. and 5.1.3 (LP13.V4) or 5.2.2 and 5.2.3 (LP14.V3). Check for gas leaks as in 5.1.5.
7. MAINTENANCE
7.1.
STORAGE
7.1.1.
Disconnect the cylinder and store it in a well ventilated area away from combustible material, preferably in an outhouse.
7.1.2.
The heater should be covered in a dry, dust free cover and placed in its original packaging.
7.2.
CLEANING
DO NOT clean the heater when it has just been turned off. Wait for the heater to fully cool.
8
7.2.1.
Use a soft, dry cloth.
DO NOT clean with aggressive, abrasive or inflammable substances, they could cause a fire or damage the paint.
8
7.3.
MAINTENANCE
7.3.1.
Any repairs must be performed by specialised personnel and using original replacement parts.
7.3.2.
To ensure proper operation of the burner, we recommend annual maintenance, performed at an authorised service centre.
DO NOT make any modifications to the heater, it is dangerous!
8
NOTE:
Spiders or small insects could take up residence inside the burner or nozzle altering the flow of gas and combustion. Inspect them
frequently.
8. TROUBLESHOOTING
FAULT
Gas leak
Inefficient combustion across the ceramic
plaque.
Burner flame extinguishes during operation.
Heater will not light.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
POSSIBLE CAUSE
Regulator and hose connection.
Valve and hose connection.
Split or perished hose
POL nut connection
Missing piece of ceramic fire clay.
Gas jet holes blocked.
Low gas or empty bottle.
Thermal element not hot enough.
The wind has extinguished the flame.
Thermal element faulty.
Faulty manual valve.
Gas cylinder valve is closed
Volume control not opened fully when
attempting ignition.
Insects inside the burner
sales@sealey.co.uk
Original Language Version
REMEDY
Brush a solution of washing up liquid and water
on to all connections and look for active bubbles.
Tighten clips or replace hose.
Check POL nut fitting is tight (ACW)
Replace plaque or repair with a compatible fire
cement and leave to set for approximately 48
hours.
Clear blockages
Change the gas bottle.
Go through the start up procedure again.
Allow to cool before restarting. Move
appliance away from draughts.
Replace the thermocouple. Contact your
Sealey stockist.
Replace the valve. Contact your Sealey
stockist.
Turn on the gas cylinder control, check for
leaks.
Read instructions 6.1 for ignition process.
Clear blockages.
www.sealey.co.uk
LP13.V4 LP14.V3
Issue 2
REGISTER YOUR
PURCHASE HERE
19/04/23
Advertisement
