1. About this Manual This manual provides the information necessary to help customers connect, install and operate the Mag900 & Mag901 three-axis magnetic field sensor. Technical specifications of the products, including power supply requirements and analogue output details, can be found in DS4550, whilst outline drawings of both sensor head, electronics...
BARTINGTON INSTRUMENTS 3. Introduction Figure 1. Mag900 & Mag901. The Mag900 & Mag901 is an unpackaged, three-axis, low power sensor intended for customer system integration. Technical specifications for the Mag900 & Mag901 are provided in datasheet DS4550. Page 4 of 10...
Internal regulation of the power supply ensures the Mag900 & Mag901 is suitable for battery powered operation, over both long and short cables (subject to the minimum supply voltage specified in datasheet DS4550).
5.3. Mounting The Mag900 & Mag901 sensor assembly should be mounted in a stress-free manner using the six mounting holes on the PCB. Dimensions and locations of the holes are shown in outline drawing DR4576.
BARTINGTON INSTRUMENTS 5.5. Pre-Installation Tests Prior to the installation into the customer’s system, the Mag900 & Mag901 must be fully tested to ensure correct function as follows: Caution: Take care to avoid bending or otherwise damaging the contacts whilst conducting the tests.
If this occurs, the offset will exhibit drift as it returns to its original offset specification. Caution: Subjecting the Mag900 & Mag901 to fields in excess of 2 x the nominal range may cause inaccuracy in future measurements. Degaussing the sensor can reverse such an effect.
Caution: Do not expose this instrument to strong magnetic fields while being stored. Caution: Take particular care when cleaning around electrical connections. Bent or damaged pins may cause the Mag900 & Mag901 to malfunction. 10. Environmental Precautions Refer to datasheet DS4550 for maximum environmental, electrical and mechanical ratings.
Page 10
®The copyright of this document is the property of Bartington Instruments Ltd. Bartington is a registered trademark of Bartington Instruments Limited in the following countries: Australia, Brazil, Canada, China, European Union, India, Israel, Japan, Mexico, New Zealand, Norway, Russia, Singapore, South Korea, Switzerland, Turkey, United Kingdom, United States of America and Vietnam.