Getting Started - XciteRC one16 Series Manual

Table of Contents

Available languages

Charging the battery · Getting started

For charging remove the battery from the vehicle.

WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,

if necessary, further safety instructions in the manual for your used charger.

• Insert the plug of the AC wall charger into the jack of the Micro-Charger, then plug the wall charger in an

appropriate mains socket 230 V/50 Hz – both LED'S (red and green) lighten up.

• Now connect the white balancer connector of drive battery to the jack on the right side of the charging

adapter.

WARNING: the connector is polarized, note the bumps. The connector must engage with

slight pressure, you not use any force - fire hazard!

• If the battery is connected with the Micro-Charger, the red LED indicates that the battery is charged. The

charging time is approx. 2.5 hours.

• The green LED indicates the end of the charging process, disconnect the battery from the charger.

• Unplug the AC adapter.

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of

the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed

or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if

necessary.

The run time of your One16s depends on the surface. The maximum run time is reached on a straight and

levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller and bat-

tery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops completely. To

increase the life time of the drive battery, you should cease operation when the vehicle begins to slow down.

1. Switch on the transmitter, ON/OFF-switch in position I.

2. Switch the vehicle ON.

to connect the transmitter with the reciever properly.

One16 series

Note: wait about 5 sec. before you move the throttle trigger. This is needed

Table of Contents

Table of Contents