Satco NUVO 62/1820 Installation And Safety Instructions

7" & 10" LED DISK LIGHTS
WITH OCCUPANCY SENSOR
Models: 62/1820, 62/1821
INSTALLATION AND SAFETY INSTRUCTIONS
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or maintenance of
• This product must be installed in accordance with applicable
installation codes by a person familiar with mentioned above
meet the latest NEC requirements and are listed in full compliance
with UL 1598.
• Supply wires must be rated minimum 90ºC. If uncertain consult
an electrician.
• The product is purposed for interior use only, suitable for wet
locations.
• Protect the product against direct contact with water.
• Assemble the product only with the use of parts provided and
the housing; improper assembly may result in device failing which
could damage the product, personal property or cause injury.
•
Cleaning
Clean with a soft or damp cloth, make sure the power is OFF.
Do not clean with liquids or abrasives.
5-Year Limited Warranty
The purchased product is covered with a 5-year warranty in respect
of any defect in material or workmanship after purchase date.
Satco shall bear no responsibility on account of guarantee, as
well as shall bear no liability for any faults, in case of improper
operation, use negligence, accident or exposure to natural hazard,
unauthorized alteration or repair followed.
OCCUPANCY SENSOR OPERATION
to adjust.
© Copyright 2022 Satco Products, Inc. 1/22, v1.1
62/1820 = 7" (177.8mm)
with Occupancy Sensor
with Occupancy Sensor
HARDWARE INCLUDED
Wire Connector Wire Connector
Qty: 3 Qty: 3
1. Area: Sensor activation area
2. 0% – 30%
3. Time: Time options from 0 to
1
62/1821 = 10" (254mm)
Junction Box Screw Junction Box Screw
Qty: 2 + 2 Extra Qty: 2 + 2 Extra
can be set for a diameter of
0ft to a maximum of 20ft.
set at default brightness of
0% (not lit in OFF condition)
or 30% (maintain 30% of full
output in OFF condition).
5 minutes for ON time after
activation.
Satco Products, Inc.
Brentwood, NY 11717