Biostar H410MH S2 2.0 Manual page 15

Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion
card into the computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely
seated in the slot.
• Secure the card's metal bracket to the chassis back panel with a screw. (This step is only
• for installing a VGA card.).
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
Note
» » Please be note that you will need to use M2 type screwdriver if you want to install or uninstall the
screw. It is recommended not to use a screwdriver that does not meet the specifications, otherwise
the screw may be damaged.
H410MH S2 2.0 | H510MHP 2.0 | B560MHP 2.0
Chapter 2: Hardware installation | 15