:lead these instructionsand the operating manual in its entirety_before you attemptto operate your new air blower.
Blower
BlowerTube
Curved Nozzle Tube
ExtensionTube
Pleated Tube
Clamp
(_,
Clamp with
Cable Guide
Combi-Wrench
_TO][o.]: _,,,."[._o_tl _[.,._
The following items for the operation of your blower are available at your nearest Sears store.
•
Safety goggles
•
Airfilter
•
Hearing protection
•
Fuel stabilizer
•
Gloves
•
Spark plug
•
2-Cycle air cooled engine oil
•
Gas can
V-!.'%'1 _hVd :]lWd
Read these instructionsand the operating manual in
its entirety before you attempt to assemble or operate
your new backpack air blower.
Your new backpack air blower has been assembled at
the factory except for the blower tubes. The necessary
clamps to complete assembly as well as a combination
wrench are included in the parts bag enclosed with the
unit.
To ensure safe and proper operation of your backpack
air blower, any clamp that you install must be
tightened securely.
HOW TO ASSEMBLE
1.
The elbow tube is already inserted intothe blower
housing. Insure that the two screws (Fig. 1, A) are
tight, but not so tight that the tube cannot be easily
swiveled.
FIGURE 1
2.
Slidethe pleatedtube (Fig. 2, E) onto the elbow
(Fig. 2, B) and secure with the clamp (Fig. 2, C)
that has an attached cable guide. Install throttle
cable (Fig. 2, D) intothe clamp cable guide.
FIGURE 2
3,
Loosenthe two screws (Fig. 3, H) on the bottomof
the attached handle clamp. Make sure that the
clamp goes over the top of the raised _
on the
undersideof the blower tube, and that the leg of
the "T" is alignedwith the slot on the clamp. Push
blower tube into the pleated tube and secure with
the plasticclamp (Fig. 3, G). The multi-function
handle (Fig. 3, F) has a 2-inch adjustment range.
Locate the most comfortablehandle location and
4