Safety Guidelines - Definitions - Black & Decker WORKMATE 125 Instruction Manual

90555796 WM125.qxd:??????-00 BDL500 laser
®
Workmate Work Center Warnings:
1. Do not load with more than 350 pounds. (160 kg)
2. Do not apply an unbalanced load which could cause the Work Center to tip over.
3. Do not use the Work Center as a stepladder or standing platform.
Do not use the lower cross brace as a step. The cross brace is a foot REST only.
4. Do not store work center outdoors or in a damp location.
5. Avoid applying excessive force when clamping with the swivel pegs.
6. Be sure that the legs are fully open, locked in position and secured via the locking
knobs.
7. When using a power tool with the Work Center, follow the safety instructions in the
toolʼs instruction manual.
8. Always wear safety glasses when operating power tools.
9. Never mount power tools directly in vise jaws; pressure may damage tools.
10. An even pressure of the vise jaws on the workpiece is essential. Tighten both crank
handles uniformly.
11. Support overhanging loads to prevent tipping.

SAFETY GUIDELINES - DEFINITIONS

It is important for you to read and understand this manual.
The information it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this information.
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION:
Indicates a potentially haz ard ous situation which, if not avoided, may
result in minor or mod er ate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
Assembly Instructions
NOTE: For assembly of the WM125 Workmate
screwdriver and the provided nut driver part (U). Assembly time is approximately 45
minutes to one hour. Follow the sequence shown in the diagrams and described in
the steps below.
STEP 1:
• Empty the contents of the box and identify all components.
1
9/25/09 12:44 PM
®
you will need a hammer, flat bladed
2
Page 2