Installation Instructions - Curtis pepsi MIS165PEP-6COM Owner's Manual

1.8 cu. ft. glass door beverage fridge
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS

LOCATION
• Two people should be used when moving theappliance.
• Remove interior and exterior packaging prior toinstallation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a lukewarm wet cloth.
• Place the appliance on a fl oor that is strong enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater,
as this can increase electrical consumption.near sources of heat, such as a stove or heater,
cause the appliance to perform improperly.
• Do not use the appliance near water, for example in a wet basement or near a sink.
• This appliance is intended for household useonly. It is not designed for outside installation,
including anywhere that is not temperaturecontrolled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power source, let it stand upright for approximately6 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• This appliance is 44.5 cm (17.5 inches) wide by 50.3 cm (19.8 inches) high by 50.0 cm(19.7 inches) deep.
Make sure that you leavethe minimum amount of space between the appliance and all surrounding walls and
vents.
• Allow 12.7 cm (5 inches) of space between theback of the appliance and the wall. Allow 5 cm (2 inches)
between the sides and top of the appliance and any walls or counter tops.
• This appliance is intended for free-standing installation only and is not intended to be
built into a cabinet or counter. Building in this appliance can cause it to malfunction.
OPER ATING INSTRUCTIONS
FEATURES
1. Thermostat Dial: (Externally mounted rear wall
thermostat) For controlling the temperature
inside the beverage center; the compressor
activates as soon as the temperature rises above
the desired level.
2. Tempered Glass Door: Tinted for UV protection
while still allowing for easy interior viewing.
3. Magnetic Door Gaskets: Tight fi tting seals retain
all the cooling power and humidity levels.
4. Plastic Coated Shelves: Odor resistant,
rustproof, and removable for easy cleaning.
5. Leveling Leg: Adjust to level the appliance.
1
3
2
2
4
5

Advertisement

Table of Contents
loading

Table of Contents