Automatic Vehicle Hold (Avh); Adaptive Cruise Control (Acc) System - BYD SEAL 2023 Quick Manual

Engaging EPB automatically
• Engaging EPB automatically when the
ignition is switched off When the
ignition is switched off, EPB engages
automatically and
instrument cluster.
• Shifting into "P" automatically: Press
the brake pedal to stop the vehicle
and engage P gear. EPB is engaged
automatically. Do not release the
brake pedal until the indicator on
the instrument cluster stops flashing
and become steady on and the "EPB
engaged" message is displayed.
Automatic EPB Release upon Vehicle
Start
• With the vehicle parked, start the
vehicle, press and hold the brake
pedal, and shift from "P" or "N"
into a driving gear such as "D" or
"R". EPB is released automatically,
the indicator goes off, and a "EPB
released" message is displayed.
Automatic Vehicle
Hold (AVH)
• Press the AVH switch to enable AVH.
A white AVH standby indicator is
displayed on the instrument cluster
and will turns green when AVH can be
enabled.
• Press the AVH switch again to disable
AVH.
8
lights up on the
Adaptive Cruise
Control (ACC)
System*
ACC on/off button
• Press button① to activate or exit
ACC. (The system is in standby when
activation conditions are met).
Resetting ACC
• When the ACC system is on standby
within the same ignition cycle, the
system memorizes the last speed
setting. Push up the lever② to revert
to the stored speed prior to exiting the
cruise system.
Increasing/Decreasing target speed
• When ACC is active, set the vehicle
to a speed within the 30~150 km/h
range by moving the lever②. Toggling
the lever② up or down each time
increases or decreases target speed by
5 km/h.
Setting vehicle distance
• The driver must select a safe vehicle
distance.
• The system adjusts vehicle speed to
keep a suitable distance from the
vehicle ahead on the same lane.
Pressing buttons ④ and ⑤ on the
steering wheel adjusts vehicle distance
to any of the four available levels. At
each level, vehicle distance is in direct