Snailax SL-623 Use & Care Manual page 5

Setup And Opera�on
※ Pre-use prepara�on
•
Before using the product, please carefully check it.
•
If this is your first �me using this product, please charge it for a while to fully
charge its ba�ery. In general, the charging �me needs to be about 1 hour or longer.
•
When charging, please connect the adapter's port to the product's charging port
and insert the adapter plug into the AC power socket.
•
When you hear the buzzer "beep" once, it indicates that the charging cable has
connected successfully and the product is star�ng to charge.(As shown below)
Type-C
•
Before using the product for the first �me, please ensure that it is fully charged.
•
The product cannot be used while charging. While charging, the charging indicator
will turn red, and when fully charged, it will turn green.
•
When the ba�ery is low, the charging indicator will flash red, and the buzzer will
beep 3 �mes, please charge it in �me.
•
Before wearing, please remove eyeglasses, contact lenses, hair accessories, etc., to
avoid discomfort during use.
•Put the massager on the eye area, and adjust the Velcro to the proper length.
※ Prepara�on before Usage
Power bu�on/Massage bu�on
1.
Long press the power bu�on for 2 seconds to turn on/ off the device, the
buzzer will beep for 1 second.
2.
A�er turning on the device, the power indicator (blue light) and hea�ng
indicator (green light) are always on, and the device starts working in
massage mode 1 and low level hea�ng
3.
Click this bu�on (short "beep" 1 sound): switch massage mode (integrated
mode, eye care mode, eye protec�on mode, sleep mode), which can be
switched in turn.
Hea�ng bu�on
Click this bu�on (short "beep" 1 sound) to turn on the heat, press con�nuously to
toggle high or low heat level, or turn off the heat.
High heat (red light), low heat (green light), off heat (light off)
USB
Adapter 5V/1A
（Not included）
Power outlet
4