CX8942 ABLE OF CONTENTS Table of contents About this document ................ 3 Warnings .................... 3 Symbols ....................3 Safety .................... 4 Proper use ..................4 Improper use ..................4 General safety information ..............4 Product description ................5 Technical data ..................5 Overview ....................
They are part of the product and contain important information required for correct operation and maintenance. These operating and installation instructions apply for all versions of the CX8942 and are intended both for specialist personnel responsible for assembly and disassembly and for end customers.
AFETY Safety Proper use The CX8942 online module LAN is used as an interface between 868 MHz- capable Uhlmann & Zacher products and a third-party system via LAN. Improper use Products from Uhlmann & Zacher GmbH must not be used to lock up persons or animals, as well as aids that are vital in an emergency (for example, defibrillators, emergency medication, fire extinguishers, etc.).
CX8942 RODUCT DESCRIPTION Product description The Clex online module LAN in the Clex public system is used as an interface between Uhlmann & Zacher locking units with 868 MHz radio and a third-party system via an Ethernet LAN connection. The product is used for the realization of radio opening, design of authorization changes and transfer of event protocols for Clex public or Clex private locking units.
CX8942 RODUCT DESCRIPTION Overview A. Without figure: Housing cover and screw(s) 1 screw for Article number 8942 0000 0000 4 screws for Article numbers 8942 0000 0004 and 8942 0000 0005 B. Screw connection for housing cover C. Mounting holes (screws not included in the scope of delivery) 1.
Avoid direct exposure to strong electromagnetic fields Do not paint over, paste over or cover the online module. Power supply The CX8942 can be supplied with voltage either via the connections or optionally via the Ethernet cable. 8-12 V DC 0.5 A max.
CX8942 ONNECTION AND INSTALLATION Installation Specify the installation position. Ensure that the surface is smooth, dry and firm enough. Do not place the units close to each other to avoid radio interferences. Unscrew and remove the housing cover. ...
CX8942 OMMISSIONING Commissioning Connecting locking units To connect a locking unit with the online module, you have to perform the following steps: Manual pairing To this purpose users must have access to the circuit board of the module to operate the rotary switch and be able to press the button.
CX8942 OMMISSIONING Network identification and authentication 5.2.1 Port The device uses port 1470. On most systems, this port can be used by normal users without special rights. 5.2.2 MAC address The online module always has four different directly consecutive MAC addresses, one for each of the basic functions of the installed LAN module.
Page 15
OMMISSIONING 5.2.3 Configuration of the network interface To carry out own settings of the IP addresses, the CX8942 has a web interface. This can be addressed either via the LAN interface or the Wi-Fi interface of the CX8942. Starting via Wi-Fi For the configuration, the CX8942 acts as a Wi-Fi Access Point (hotspot).
Page 16
CX8942 OMMISSIONING Changing the Tap the button "Configure network". password Select the "HTTP Basic Auth" under the item "Configure portal protection". Select a secure password for the user "admin". Access to If the module is started by pressing the button in the Wi-Fi configuration mode as described above, the LAN interface is not active.
CX8942 OMMISSIONING Configuring the online module The configuration of the online mode normally takes place through the connected third-party system and the corresponding function of the respective protocols. Individual parameters of the online module can also be set directly via a 868 MHz-connection or bus commands in the service mode.
CX8942 PERATION Operation If an authorized transponder is held in front of the connected locking unit, a radio connection is established with the online module and, depending on the version, the authorization is requested via the corresponding protocol of the third-party system.
CX8942 PERATION Signaling Meaning Green Network connection is established and IP address is being called rapid flashing Green The module can be reached as a Wi-Fi access point to carry out the initial configuration (see slow flashing section 5.2.3Fehler! Verweisquelle konnte nicht gefunden werden.
CX8942 ISASSEMBLY AND DISPOSAL Disassembly and disposal Disassembly Disposal Do not dispose of the device with household waste, but at a municipal collection point for special electrical waste in accordance with European Directive 2002/96/EC. Dispose of packaging as environmentally friendly recycling.
CX8942 LOSSARY Glossary Term Meaning German "Verband der Elektrotechnik" [Registered Association of the Electrical, Electronic and Information Technology] Power supply via Ethernet (abbreviation of: Power over Ethernet) phg_crypt Standard protocol of the company phg Peter Hengstler GmbH + Co. KG, Deißlingen in Germany...