Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Green Power GNLS05T-1020H
- Page 1 Mode l : GNLS0 5 T - 1 0 2 0 H www. g r e e n - p o we r a me r i c a . c o m...
-
Page 2: Safety Warnings & Cautions
SAFETY WARNINGS & CAUTIONS SYMBOL AFFIXED TO THE SAFETY WARNINGS & INSTRUCTIONS MACHINE UNDERSTAND YOUR LOG SPLITTER Read and understand the owner’s manual and labels affixed to the log splitter. Learn its application and limitations as well as the specific potential hazards peculiar to it. DRUGS, ALCOHOL AND MEDICATION Do not operate the log splitter while under the influence of drugs, alcohol, or any medication that could affect your ability to use it... - Page 3 EXTENSION CORDS Improper use of extension cords may cause inefficient operation of the log splitter which can result in overheating. Be sure the extension cord is no longer than 33feet and its section is no less than 2.5mm to allow sufficient current flow to the motor. Avoid use of free and inadequately insulated connections.
-
Page 4: Table Of Contents
PROTECT YOUR HANDS Keep you hands away from splits and cracks which open in the log; They may close suddenly and crush or amputate your hands. Do not remove jammed logs with you hands. DON’T FORCE TOOL It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in the specifications table. -
Page 5: Application Conditions
G N L S 0 5 T - 1 0 2 0 H... -
Page 6: Set Up And Preparation For Operation
SET UP AND PREPARATION FOR OPERATION 1. Bolt the Support Leg to the Log Splitter, lift the log splitter by the handles at both ends and place it on a 23.6 - 29.5in high, stable, flat and level work surface. 2. -
Page 7: Wiring Diagram
15. Max Pressure Limiting Screw DO NOT ADJUST THE MAX PRESSURE LIMITING SCREW ! Max pressure was set before the log splitter ex work and the max pressure limiting screw is sealed with glue to ensure the log splitter works under pressure no more than 5 tons. -
Page 8: Log Splitter Operation
LOG SPLITTER OPERATION This log splitter is equipped with “ZHB” control system that requires to be operated by both hands of the user – Left hand controls the hydraulic control lever while right hand controls the pushbutton switch. The log splitter will freeze upon absence of either hand. Only after both hands release the controls, the log pusher starts to return backward to the starting position. -
Page 9: Freeing A Jammed Log
Break log in the direction of its growing grain. Do not place log across the log splitter for splitting. It may be dangerous and may seriously damage the machine. Do not attempt to split 2 pieces of logs at the same time. One of them may fly up and hit you. -
Page 10: Replacing Hydraulic Oil
REPLACING HYDRAULIC OIL Replace the Hydraulic oil in the log splitter after every 150 hours of use. Take following steps to replace it. Make sure all moving parts stops and the log splitter is unplugged. Unscrew Oil Drain Bolt with Dipstick to remove it. -
Page 11: Sharpening Wedge
SHARPENING WEDGE After using the log splitters for some time, sharpen the wedge of the log splitter using a fine-toothed file and smooth any burrs or crushed area along the cutting edge. TROUBLE SHOOTING PROBLEM PROBABLE CAUSE REMEDY SUGGESTED Overload Protection Device Contact a qualified Electrician for opening... - Page 13 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5...
- Page 14 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5 G N L S 0 5...
Need help?
Do you have a question about the GNLS05T-1020H and is the answer not in the manual?
Questions and answers