Larson Electronics LM-SYM-XX-CTRL-R1 Instruction Manual

Master Control Box for Syncing LM-SYM Series Masts 3rd Gen - Class 1 Div 1 -
Thank you for your purchase of the Larson Electronics LM-SYM-XX-CTRL-R1.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
•
RELEVANT LOCAL BUILDING CODES.
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
•
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
The Larson Electronics LM-SYM-XX-CTRL-R1 Master Control Box provides a safe and effective way for operators to sync LM-SYM
series masts. Suitable for syncing up to 4 LM-SYM series electric winch masts, the unit facilitates start, stop and emergency stop
functions.
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
where weatherproofing may be required. Universal voltage driver permits operation at 100V - 277V AC, 50 or 60Hz
except those factory ordered with low voltage 11V to 25V AC/DC.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram 
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
MOUNTING
This unit is intended to be surface mounted to desired location.
OPERATION
• Ensure sync cables are plugged in to desired towers and towers are connected
to a power source.
• For single tower operation, put the switch inside the Master Control Box to
"STOP".
• For synchronized tower operation, put the switch inside the Master Control
Box to "RUN".
Larson Electronics, LLC
Sync up to (4) Masts - LCD DIsplay, (3) Buttons
Instruction Manual
precautionary steps
Phone: (800) 369-6671
, in all locations especially in outdoor areas
for weatherproofing all
Fax: (903) 498-3364
LM-SYM-XX-CTRL-R1
www.larsonelectronics.com
1 of 2