Download Print this page

Baby Trend PY86A Manual page 6

Nursery center

Advertisement

ASSEMBLY MONTAJE ASSEMBLAGE
TO ASSEMBLE PLAYARD
ARMADO DEL CORRALITO
ASSEMBLAGE DU PARC DE BÉBÉ
Playard
Corralito
Parc
Playard must be fully assembled and securely locked before
ATTENTION:
installing or using other accessories.
El corralito debe estar totalmente armado y trabado de manera
ATENCIÓN:
segura antes de instalar o usar otros accesorios.
Le parc de bébé doit être totalement monté et
ATTENTION :
verrouillé avant d'installer ou d'utiliser d'autres accessoires.
Fig. 1
11
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Mattress
Colchón
Matelas
• Unzip bag and remove Playard frame (Fig. 1).
1)
Undo the fasten straps and set the Mattress
aside.
DO NOT push center down yet.
• Abra la bolsa y saque el armazón del corralito
(Fig. 1). Desabroche correas de sujeción y
ponga el colchón a un lado.
Todavía NO empuje el centro hacia abajo.
• Ouvrez le sac et enlevez le cadre (Fig. 1).
Desserrer les bandes en crochet et boucle
fermeture et mettre le matelas de côté.
NE PAS pousser le centre du parc vers le bas.
ASSEMBLY MONTAJE ASSEMBLAGE
• Top rails must be fully erected before lowering
2)
center. Pull up one rail at a time, hold one hand
on each side of the rail and pull up sharply, do
not pull from the middle where the center latch
release is located, make sure both tubes latch
in place and each rail is rigid (Fig. 2).
IMPORTANT: The handle located in the
center of the Playard floor MUST remain
raised (Approx. 45.7 cm or 18 inches)
while locking the side rails in place. If the
center is not raised the rails will NOT lock.
If you experience difficulty and one side of the
rail will lock but the other side will not then,
unlock the rail by squeezing the release in the
center and try again.
• Las barandillas superiores deben estar
completamente erguidas antes de bajar
el centro. Levante una barandilla por vez,
coloque una mano a cada lado de la barandilla
y levante fuertemente. No jale del medio,
donde se ubica el mecanismo de liberación del
sujetador central. Asegúrese de que ambos
tubos estén asegurados en su lugar y que
todas las barandillas estén rígidas (Fig. 2).
IMPORTANTE: La manija ubicada en
el centro del piso del corralito DEBE
permanecer levantada (aprox. 45.7 cm o
18 pulg.) mientras se traban en su lugar
las barandas laterales. Si el centro no está
levantado, las barandas NO se trabarán.
Si tiene dificultades y se traba sólo un lado de
la baranda pero el otro no, destrabe la baranda
apretando el botón de liberación que se
encuentra en el centro e intente nuevamente.
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 2
12

Advertisement

loading