Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Powermat PM-PKA-20C
Summary of Contents for Powermat PM-PKA-20C
- Page 1 PM0760 USER MANUAL BATTERY TRIMMER PM-PKA-20C ORIGINAL INSTRUCTIONS...
-
Page 2: Table Of Contents
Table of Contents Table of Contents ..............................2 WARNING / INFORMATION SYMBOLS ..................3 INTENDED USE OF THE DEVICE ......................... 4 SAFETY RULES ........................5 General safety instructions ....................5 Protection against electric shock ..................5 Safety instructions for working with the trimmer .......... -
Page 3: Warning / Information Symbols
WARNING / INFORMATION SYMBOLS ATTENTION: Before using the device, carefully read the operating instructions and safety ATTENTION: Before using the device, carefully read the operating instructions and safety instructions. Keep the instructions. ATTENTION: The charger should only be used in dry rooms. ATTENTION: The charger should only be used in dry rooms. -
Page 4: Intended Use Of The Device
Read the section "DISPOSAL OF USED DEVICES" APPLICATION The cordless grass trimmer from POWERMAT is designed for trimming and trimming grass on lawns in home gardens and allotments. The device is not intended for professional work. -
Page 5: Safety Rules
For safety reasons, the POWERMAT battery trimmer cannot be used for trimming hedges or shredding compost mass. It is forbidden to use the device during rain or in humid environment. The manufacturer is not liable for damages resulting from improper use or incorrect operation. -
Page 6: Safety Instructions For Working With The Trimmer
The cord cross section should be at least 1.0 mm The cord cross section should be at least 1.0 mm The cord cross section should be at least 1.0 mm Unwind the cord completely from the drum before using it. Check the cable for Unwind the cord completely from the drum before using it. -
Page 7: Maintenance And Storage
cause electrolyte leakage and / or an internal short circuit that leads to the generation of heat causing the file to break or break. In addition, do not dispose of batteries in a fire as they may explode. • Under extreme conditions, battery leakage may occur. If fluid appears on the battery, proceed as follows: Carefully wipe the liquid with a cloth. -
Page 8: Service
SERVICE Electrical tools should be repaired only by qualified personnel using original spare parts. This ensures safe use of the device. Address: Powermat service ul. Obrońców Poczty Gdańskiej 97 42-400 Zawiercie Tel. 32 670 39 68, internal 4 e-mail: serwis@powermat.pl WARRANTY During the warranty period, the buyer is entitled to free repairs resulting from manufacturing defects. -
Page 9: Description Of The Device Construction
DESCRIPTION OF THE DEVICE No. | Mark No. | Mark Lock against accidental activation On button Additional handle Handle rotation lock knob Telescopic rod locking sleeve Container for spare cutting knives Telescopic tube Rotary handle 10 Protective cover 10 Protective cover Button for adjusting the angle of the cutting unit 11 Guide roller for edge cutting 11 Guide roller for edge cutting... -
Page 10: Device Installation
DEVICE INSTALLATION Before working on the device, disconnect the device from the power supply. INSTALLING THE ROLL TO GUARD CUTTING INSTALLING THE ROLL TO GUARD CUTTING • Take out the guide wheel and the matching screw, position it as pictured. •... -
Page 11: Adjusting The Angle Of The Additional Handle
ADJUSTMENT OF AN ADDITIONAL HANDLE ANGLE ADJUSTMENT OF AN ADDITIONAL HANDLE ANGLE • Take the auxiliary handle (3) out of the box. • Loosen the knob (4), remove the long screw, then carry out the assembly as shown in the figure. TRIMMING LENGTH ADJUSTMENT TRIMMING LENGTH ADJUSTMENT •... -
Page 12: Operating The Battery Trimmer
Warning: Remove the battery from the trimmer before setting the angle. Warning: Always wear safety glasses. Never lean over the cutting head. Stones or debris can bounce or be thrown into the eyes and face and blind or cause serious injury. To use the device, pay attention to the following points: •... -
Page 13: Description Of Work With The Device
3. To stop the engine speed, release the on / off switch (2). 3. To stop the engine speed, release the on / off switch (2). ABOUT ABOUT LIST OF WORK WITH THE DEVICE LIST OF WORK WITH THE DEVICE Trimming and trimming the edges WARNING! Before starting work, remove stones, pieces of wood and other objects from the lawn. -
Page 14: Charging And Changing The Battery
A noticeable lack of grass cutting when the head constantly rotates is caused by the lack of a fishing line or the lack of extension of and) the right length. Only at the maximum length of the cutting line is the cut evenly cut. b) When after turning off the spool b) When after turning off the spool line... -
Page 15: Battery Connection / Disconnection
DISCONNECTING / DISCONNECTING THE BATTERY DISCONNECTING / DISCONNECTING THE BATTERY WARNING: Before making any adjustments, make sure that the tool is turned off. • Hold the tool with one hand and the other with the battery. • To install: push and slide the battery into the battery port, make sure that the release latch on the back of the battery snaps into place and the battery is secure before you start working. -
Page 16: Part Diagram
PART DIAGRAM... -
Page 17: Disposal Of Used Devices
You can also refer the old device to a collection point. For more information on storage points for used equipment, please visit: https://sklep.powermat.pl/webpage/pl/recycling.html MANUFACTURER'S DATA PH Powermat TMK Bijak Sp. Jawna Ul. Obrońców Poczty Gdańskiej 97 42-400 Zawiercie https://powermat.pl... -
Page 18: Declaration Of Conformity
DECLARATION OF CONFORMITY...
Need help?
Do you have a question about the PM-PKA-20C and is the answer not in the manual?
Questions and answers