Summary of Contents for GDI GOLD X-FINDER
- Page 1 Long Range Locator Version 3. Firmware v1.06 - May 2022 X-FINDER youtube video guide: https://youtu.be/WkRnv9HlUDo users unexperienced to similar devices please note the conditions of operation at pages 2,3 & 4...
-
Page 2: Detection Conditions
Τhank you for your purchase of the GOLD X-FINDER distant locator by GDI - Gold Detectors International. As a manufacturer we have invest a long time in research and development and have taken all efforts to produce a quality locator of this type, that has not an equal to the treasure hunting market. - Page 3 When GOLD X-FINDER senses a target the antenna points towards this direction and locks. To double check the target, point with the antenna to another spot or a different...
-
Page 4: Mode Selection
Equally important to the handling is user conductivity. Individuals with high conductivity have the ability to operate GOLD X-FINDER successfully by the first attempt. The rest have to go through proper adjustment of their body and optimize their conductivity by practicing. If another individual with a high body conductivity is with you, let him amplify your adjustment procedure with the GOLD X-FINDER by touching your hand that holds the locator. -
Page 5: Fine Frequency Tuning
Μ2: SILVER [Ag] 8700 Hz, Μ3: IRON [Fe] 16800 Hz, Μ4: LEAD [Pb] 4000 Hz, Μ5: ALUMINIUM [Al] 6800 Hz Μ6: BRONZE 11800 Hz, Μ7: COPPER [Cu] 11200 Hz, Μ8: DIAMOND [C] 12200 Hz, M9: WATER [H2O] 9500 Hz, M10: VOID 200 Hz, M11-M13*: FREE MODES 0 – 20000 Hz ( *free modes where the user stores manually -using the arrows- the preferred frequency to experiment ) FINE FREQUENCY TUNING By a single press of arrow key the element frequency... -
Page 6: Sensitivity Adjustment
Position 1 SENSITIVITY ADJUSTMENT For a precise centering, reduce GOLD X-FINDER sensitivity when near the target area, by shortening the antenna. Doing so, lowers the detection range and the ability to locate small objects is eliminated. Also the locator operates stable against small scale interference caused for example by electromagnetic fields or minerals. - Page 7 Maybe the signal center is displaced however by the interference. For more accurate rejection of magnetic fields and small sized targets use the ELIMINATOR e120 B by GDI over the signal line already discovered. SOLAR ACTIVITY INTERFERENCE When scanning under intense sunlight, in the heat and in noon during the summertime, the strong sun radiation may cover and mask fully the target signal.
- Page 8 The detector inspection if offered free of charge. The delivery charges to / and from the repair center are the customers responsibility. Only the GDI repair center has the right to define the nature and existence of the fault. When the guarantee times out the repairs might have a chargeable cost that the user will be notified of.
- Page 9 GDI GEOPHYSICAL INSTRUMENTS © 2022 193 Athinon avenue, 12461 Athens Greece. Tel.: +30 210 4905398 Web. http://www.gdi-detectors.com...