RAB XDIM Instructions

INSTRUCTIONS
Phase Dimmer

IMPORTANT

TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF AT THE FUSE BOX BEFORE INSTALLATION.
WARNINGS and CAUTIONS:
● To avoid risk of fire and electrical shock, products shall be installed in accordance with electrical code and regulations.
● The product shall be used together with an air-break switch.
● Cut off the power at the circuit breaker or fuse before installation.
● After installing the dimmer, it's recommended to set the minimum brightness level to make bulbs turn on immediately and
the dimmer with maximum dimming range.
●
If you're not clear about any content of the instructions, please consult the licensed electrician.
●
Switch to the leading mode when the inductive load is used.
●
To avoid the risk of overheating and possible damage to the equipment, do not use the product to control the receptacle,
motor-operated appliance or a transformer-supplied appliance.
●
Product should only be used with compatible dimmable LED, CFL, incandescent or halogen products.
●
When connecting multiple products with a single dimmer, do not mix product types. All products shall be either dimmable
LED, CFL or incandescent products. Using the same type of products will enhance dimmer performance.
● This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.

WHAT'S IN THE BOX

Base Plate
Dimmer (1 pcs)
(1 pcs)
5PIN Wiring 2PIN Wiring
Terminal (2 pcs) Terminal (3 pcs)
XDIM
Jumper Wire
(1 pcs)
Face Plate Mounting Screws
(1 pcs) (2 pcs)
Connection Wire (5 pcs)

TOOLS NEEDED

●
5mm Philips Screwdriver
●
Electrical Tape
●
Electrician Knife
●
Test Pencil
●
Pliers
●
Ruler