Right-Hand, Left Hand and Front Hand Replacement
Mower
2011 and After Groundsmaster
Model No. 30476—Serial No. 312000001 and Up
Model No. 30477—Serial No. 312000001 and Up
Model No. 30478—Serial No. 312000001 and Up
Remove Hydraulic Motor
(Front or Side Decks)
1. Position machine on a level surface, lower cutting
units to the ground, engage parking brake, be sure
traction pedal is in neutral position, PTO lever in
OFF position, shut engine OFF and remove key
from switch.
2. Remove bolts securing hydraulic motor to deck
(Figure 1). Lift motor off deck and lay it on a clean,
out of the way, surface. Do not damage aluminium
coupler.
1. Hydraulic motor
3. Remove elastomeric spider from inside pulley
coupler. Inspect for wear and replace if worn.
Otherwise, retain for installation on new front deck
(Figure 2).
Note: Inspect spider hub for wear and replace if
worn (Figure 2).
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
2. Mounting bolts
Register at www.Toro.com.
®
4000-D Traction Unit
Figure 2
1. Spider
2. Spider hub
Replace Front Mower Deck
1. Remove hair pin cotters and clevis pins securing
height-of-cut chains to rear of deck (Figure 3).
Retain hair pin cotters and clevis pins for installation
on new front deck.
Figure 3
1. Height of cut chain
Form No. 3370-469 Rev A
Installation Instructions
3. Pulley coupler
2. Clevis pin & hair pin cotter
Original Instructions (EN)
Printed in the USA.
All Rights Reserved