Toro 30674 Operator's Manual page 30

Replacing the Fuel Filter
Service Interval: Every 200 hours/Yearly (whichever comes
first)
Never install a dirty filter if it is removed from the fuel line.
Note: Note how the fuel filter is installed in order to install
the new filter correctly.
Note: Wipe up any spilled fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Close the fuel-shutoff valve at the fuel tank
4. Squeeze the ends of the hose clamps together and slide
them away from the filter
Figure 35
1. Hose clamp
2. Fuel line
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps close to
the filter.
7. Open the fuel-shutoff valve at the fuel tank
8. Check for fuel leaks, and repair if needed.
9. Wipe up any fuel that spilled.
Servicing the Fuel-Vent System
Service Interval: Every 200 hours/Yearly (whichever comes
first)
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the existing fuel-vent filter
4. Install a new filter.
(Figure
(Figure 35).
3. Filter
(Figure
(Figure 36).
34).
1 2
1. Fuel-vent filter
34).
30
g014686
Figure 36
2. Right side of engine