Table of Contents
Advertisement
4. Connecting your OM-ES-020 Device
1.
Connect the OM-ES-020 device to your local network or use a direct
cable connection using a standard straight-through or crossover
Ethernet cable and plugging into the Ethernet port connection.
2.
Connecting to Power: Connect the power adapter or a DC power line
(5-30V) to the OM-ES-020 power terminal block or jack connection
using your own power supply please check input requirements on page 5 - Hardware
3.
When the Status LED turns steady green (after 5-60 seconds), the
device is ready to use.
4.
Connect the serial cable from your serial device to the serial port on the
OM-ES-020 device. Refer to Section 8 of this Quick Start Guide for pin
outs.
Make a note of device MAC address (on side panel, 00-0a-4f-XX-XX-XX) as
you will need it to identify the device on your network later.
*If
6
Advertisement
Table of Contents
