Advertisement
INSTRUCTION MANUAL FOR PUNCHER
SI-4900
φ6.5×2
Component Name
Arm head
Oil inlet
Throttle lever
Exhaust
Accessories:
• 4mm Allen Wrench （ 1）
• Safety Instructions （ 1）
Operation Procedures
1.Connect a coupler in the air inlet of the motor housing.
The arm head can rotate in the 360 degree range.
2.Pour approx. 5cc (2 to 3 drops) of the oil through the
installed coupler, and do idling run for 3 to 5 seconds.
Punching Work hole Position
SI-4900
SI-4910
Component Name
Punch guide
Throttle lever
Air inlet
Accessories:
• 4mm Allen Wrench （ 1）
• Safety Instructions （ 1）
3.Determine the position according to servicing points.
4.Pull the throttle lever, and the tool will operate. Release it
to stop thee operation.
SI-4910
φ5/φ6.5
Arm head
Oil inlet
Exhaust
Punch guide
Air inlet
Advertisement
Table of Contents
Summary of Contents for Shinano SI-4900
- Page 1 INSTRUCTION MANUAL FOR PUNCHER SI-4900 SI-4910 φ6.5×2 φ5/φ6.5 Component Name Component Name Arm head Arm head Punch guide Punch guide Oil inlet Oil inlet Throttle lever Throttle lever Exhaust Exhaust Air inlet Air inlet Accessories: Accessories: • 4mm Allen Wrench （ 1）...
- Page 2 Specifications Avg.Air Model Cutting. cap Weight Vibration Panching Cap Consumption Number mm/(in.) kg/(lb) CFM (L/S) SI-4900 1.0/(3/64) 1.00/(2.20) < 2.5 1.3/(0.6) φ6.5×2 SI-4910 1.0/(3/64) 1.00/(2.20) < 2.5 1.3/(0.6) φ5/φ6.5 How to inject hydraulic oil If the tool power is down during punching work the failure may almost cause due to oil shortage. Supply oil according to the procedures as shown below.
Need help?
Do you have a question about the SI-4900 and is the answer not in the manual?
Questions and answers