Seat Adjustment Lever; Fuses; Cutting Height Pedals - RedMax CZT60x Operator's Manual

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways with the
lever located at the right side of the seat (as
seen by the driver in the seat). When making
adjustments the lever is moved up.
Adjustments may be made to seat suspension by
turning the center knob.
IMPORTANT INFORMATION
be adjusted while the unit is in motion.

Fuses

Fuses are located on the right hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.
Seat should not

Cutting Height Pedals

The cutting height pedals release the deck lift and
set the desired deck height. Apply pressure to the
lift pedal and rotate foot to also apply pressure to
the release pedal, unlocking the deck lift.
For transport, push the lift pedal forward until the
deck lift latches in the transport (highest) position.
To set the deck cutting height, release deck height
control by pushing forward on the pedal. Rotate
the cutting height pin 180
the pin into the hole for the desired cutting height.
The cutting height can be set from 1"- 5".
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
O
to remove it and slip
15