Subscribe to Our Youtube Channel
Summary of Contents for Girard Systems GC116I
- Page 1 12v ANEMOMETER GC116I INSTALLATION AND PROGRAMING GUIDE REV.12302015 RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673(800) 382-8442 FAX (949)276-5500 www.girardrv.com...
- Page 2 Shore Power – if connected; Generator Power – if the generator is running; Inverter Power – batteries must be charged for inverter operation. Girard Systems awnings are supplied with an electric motor appropriate to the product. Page 2 of 10...
-
Page 3: Table Of Contents
These components must be electronically matched, programmed or paired before use. This is usually done at the Girard Systems factory. Should the need arise for the user to pair a device with the motor controller they must refer to the appropriate manual for the devices applicable to their particular installation. -
Page 4: Product Description
PRODUCT DESCRIPTION The GC116I Anemometer is a 12v DC Remote module designed to operate in conjunction with all Girard Systems G-Link motor controllers. This device will send an All Channels Retract signal whenever the wind speed exceeds a pre-set value for longer than 3 seconds. -
Page 5: Set Up And Programming
SET UP AND PROGRAMMING The GC116I Anemometer must be programmed/matched/paired with whichever device controls the motor of the awning or awnings to be retracted in windy conditions. First ensure that there is power to the motor controller, and then fully extend the awning. -
Page 6: Pairing With A Gc274A
PAIRING WITH A GC274A Locate and ensure access to the program button of the motor controller. In this case the lid of the 274A must be removed to gain access to the program button. STOP BUTTON PROGRAM BUTTON Note; when carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. -
Page 7: Pairing With A Gc274B
PAIRING WITH A GC274B Locate and ensure access to the program button of the motor controller. In this case the middle and right buttons must be pressed and held untill the Green LED begins to flash. STOP PROGRAM Note; when carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. -
Page 8: Pairing With A Gc732G
PAIRING WITH A GC732G Locate and ensure access to the program button of the motor controller. In this case the program button is easily accessed on the side of the box. PROGRAM BUTTON Note; when carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings. -
Page 9: Pairing With A Gc1146C
PAIRING WITH A GC1146C Locate and ensure access to the P2 button for the motor controller. In this case the program button is found on the back of the primary handset and a toothpick or similar tool will be required to press it. P2 BUTTON Note;... -
Page 10: Pairing With A 98Gc74
5) Press the up button on the Anemometer or physically activate it by spinning the cups to retract the awning. For queries or assistance with programming any of your G-Link devices please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T. Page 10 of 10...
Need help?
Do you have a question about the GC116I and is the answer not in the manual?
Questions and answers