Page 2
INTRODUCTION Switch into fun with the Switch & Go Triceratops Fire Truck. ® Transform a cool Fire Truck into a Triceratops and back in just a few simple steps. Launch the Water Burst and release the Rescue Motorcycle. Let’s go! Water Burst Button Voice Button LCD Screen...
INCLUDED IN THE PACKAGE Switch & Go Triceratops Fire Truck • ® • Quick Start Guide WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. NOTE Please save this Instruction Manual as it contains important information.
GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover located on the bottom of the unit and use a screwdriver to loosen the screw, then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4.
IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used.
IMPORTANT : INFORMATIONS CONCERNANT LES PILES Les piles fournies avec le produit permettent de tester le jouet en magasin mais ne sont pas des piles longue durée. • Mettre en place les piles ou les accumulateurs en respectant les polarités + et –. •...
PRODUCT FEATURES 1. Off/Low/High Volume Selector To turn the unit On or to adjust the volume, slide the Off/Low/High Volume Selector to the Low or High volume position. To turn the unit Off, slide the selector to the Off position. 2.
6. LED Lights The LED lights flash along with the sounds in Dino mode and Vehicle mode. 7. AUTOMATIC SHUT-OFF To preserve battery life, the Triceratops Fire Truck will automatically shut off after approximately 20 seconds without input. The unit can be turned on again by pressing the Voice Button or by switching between Dino and Vehicle modes.
Page 9
3. Adjust the water launcher 4. Aim the water launcher launcher backward. forward. 5. Flip up the tail. 6. Flip out the rear legs. 7. Flip the rear legs up. 8. Rotate the lower legs up.
Page 10
9. Rotate the lower legs. 10. Flip the front legs up. 11. Rotate each front leg and 12. Flip the front bumpers out. shoulder. 13. Push the front bumpers 14. The unit is now in and wheels in. Vehicle mode. To switch back to Dino mode, reverse the steps above.
CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat source. 3. Remove the batteries if the unit will not be in use for an extended period of time.
Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products.
Page 13
Model: 5494 Product Name: Switch & Go Triceratops Fire Truck ® Responsible Party: VTech Electronics North America, L.L.C. Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004 Website: vtechkids.com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
Need help?
Do you have a question about the Switch & Go Triceratops Fire Truck and is the answer not in the manual?
Questions and answers