TABLE OF CONTENTS SUBJECT OF THE DOCUMENTATION ..................3 PRODUCT IDENTIFICATION......................3 TECHNICAL SPECIFICATION ......................4 Structure ..............................4 Electrical components ....................... 6 Fabric components in the roller blind................8 Technical limitations of the fabrics ................10 ROLLER BLINDS USER MANUAL AND GENERAL SAFETY REGULATIONS ....10 CERTIFICATES ............................
This booklet also contains guidelines for use and service activities. PRODUCT IDENTIFICATION The following describes the roller blinds with trade names Screener 110 ZIP and Screener 110. This system represents a perfect solution for protecting the building against excessive sunlight, overheating, and wind gusts, without obscuring the view to the outside and ensuring optimum lighting.
The calculations concerning wind load resistance were performed according to the standard PN - EN 1932: 2013 - 09 - EXTERNAL BLINDS AND SHUTTERS - RESISTANCE TO WIND LOADS METHOD OF TESTING. Familiarizing oneself with the manual shall ensure the proper functioning of the product. Compliance with the guidelines therein shall ensure durability of the roller blind.
Electrical components Tarasola cooperates with the best suppliers on the market in order to ensure the highest level of offered products. Thanks to the electrical components used in our products, we are offering a comprehensive product to our Clients - the best on the market.
Page 7
Rys.4 Electrical drive with a switch. It is not recommended to connect more than one motor to one switch (and vice versa). The exception is having a switchboard. WARNING! All wiring connection diagrams shall be obeyed, otherwise warranty may be voided. REMOTE CONTROLLER Manual radio control of one or more RTS drives and/ or radio receivers or a group of •...
When the roller blinds are switched on please pay particular attention to: proper unwinding and winding of the fabric, • correct operation of the limit switches set by the manufacturer. • A detailed description of the operation of electrical components can be found in a separate user manual.
Page 9
SOLTIS 86 1100 Dtex polyester with double-sided PVC coating; micro-perforated PVC cover; shiny coating; weight: 380g/m²; max. stretch: warp – 230kg, weft – 160kg; 1 class of fire resistance UNI 9177-87. Cleaning and care: water, light detergent + soft cloth. SOLTIS 92 1100 Dtex polyester with double-sided PVC coating;...
Technical limitations of the fabrics Rot resistance – the canopy fabrics are usually made of synthetic materials, which do not contain any biodegradable substances. This, in turn, makes them rot-proof. The accumulation of dirt and other naturally occurring substances on the fabric surface, coupled with moisture, may create very good conditions for fabric degradation.
Page 11
The roller blind shall be used for a maximum of 50 opening and closing cycles per day. Repeated unfolding and folding of the roller blind may overheat the electric drive, thus activating the thermal switch which shall disconnect the power supply. The motor shall remain off until the temperature is adjusted.
Page 12
Maintenance work shall be performed when the roller blind is not working. Do not use sharp or rough tools to clean the roller blind. Clean the surface with water and a small amount of light detergents with a neutral pH (such actions shall be performed when the outside temperature stands between 10°C and 25°C).
Page 13
It is forbidden to unfold the roller blind during snowfall and hail. Failure to comply with this recommendation may damage the fabric, reduce its properties and, as a result, tear it. During rainfall, snowfall, hail and strong winds (exceeding the permissible standards for a given size of the roller blind), the roller blind shall be folded immediately.
Page 14
The installation of the roller blind is a clean job, so it is not advisable to install the roller blind during an ongoing renovation. It is best to postpone the installation work until after the renovation shall be completed. In case a roller blind is installed during a renovation, then it is best to dismantle such an installed roller blind in order to avoid possible damage to the varnish-coated cassette or the fabric.