Universal UNV84600 - Laminator Manual

SAVE THESE INSTRUCTIONS

SAFETY INSTRUCTIONS

NOTE: READ ALL SAFETY INSTRUCTIONS BEFORE USE

The safety recommendations outlined in this section should be read and understood before operating this machine. When using this machine follow these basic safety precautions to reduce risk of fire, electric shock or injury. Keep this information for future reference.

1. To prevent the possibility of a fire or injury, do not allow foreign articles inside the machine.
2. Do not attempt to laminate items that exceed total recommended material thickness.
3. To prevent the possibility of electric shock, do not immerse the laminator in water or permit liquids inside the machine.
4. Because the laminator creates heat, keep out of the reach of children.
5. Do not cut pouches before inserting them into the laminator. This will cause the laminator to jam.
6. Do not laminate leaves, flowers, clothes etc.
7. Do not use the machine if the cord is damaged. This may result in electric shock, fire, or other hazards.

How to load a laminating pouch

The laminating pouch is sealed along one side. Open the pouch and place the item to be laminated centrally and as close to the sealed edge as possible. The sealed edge is then placed into the entry slot to start the laminating process.

Release Button

Should the pouch become jammed during the laminating process turn the machine off and press and hold the 'release' button and remove the item.

CONTROLS

Sealed laminate end must go in first

OPERATION

Hot Lamination

1. Place the machine on a flat, sturdy surface and Set the Laminator to 'Hot'. Press the power button 'ON'
2. The machine will take approximately 3-5 minutes to warm- up, When 'ready' the Green "Ready" light turns on.
3. Place the item to be laminated into the laminating pouch.
4. The document or photo will then automatically feed out the through the back of the machine.

Cold Lamination

Note: If the machine was previously used in hot setting, allow approximately 25minutes for the machine to cool down.

1. Place the machine on a flat, sturdy surface. Set the Laminator to 'Cold'. Press the power button 'ON'.
2. The green ready light will turn on.

TROUBLESHOOTING

SPECIFICATIONS

Manufactured for Universal®/ Essendant Co.
One Parkway North Deerfield, IL 60015 ©2017 Essendant Co.
Made in China