Toro 31853 Operator's Manual page 8

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Mounting the Battery Charger (Optional)
Parts needed for this procedure:
2 Mounting hardware (not included)
Procedure
If desired, mount the battery charger securely on a wall using the wall-mount key holes on the back of the
charger.
Mount it indoors (such as a garage or other dry place), near a power outlet, and out of the reach of children.
Refer to Figure 3 for assistance in mounting the charger.
Slide the charger over the appropriately positioned hardware to secure the charger in place (hardware not
included).
Description
Mounting hardware (not included)
No parts required
Chute deflector
Chute-control rod
Qty.
2 Mount the battery charger (optional).
–
Unfold the handle.
1 Install the chute deflector.
1 Install the chute-control rod.
Figure 3
8
Use
g290534