Maintenance; Troubleshooting - Snailax SL-402 Use & Care Manual

• Remove the adapter from the outlet when not in use.
• Do not setup or use the massager in a bathroom or similary wet / damp areas.
• For your own safety we equip the massager with a protec�on against over-hea�ng
The massager will switch off automa�cally and will only allow switching on again
a�er an appropriate down�me.
• Likewise, you should allow your body some rest periods. To avoid straining your muscles
too much, we recommend to not exceed a con�nuous massage of 15 Minutes.

MAINTENANCE

TO STORE
Unplug the appliance from the outlet and allow it to cool before storing in its box or in a cool, dry
place. Coil the cord and secure it with the supplied fastener. Do not hang the unit by the power
cord.
TO CLEAN
• The detachable massage head plush pads are hand/machine washable.
• Clean the machine only with a so�, damp cloth and mild cleansing agent. Never allow water or
any other liquids to come into contact with the massager.
• DO NOT immerse the machine in any liquid to clean.
• NEVER use strong abrasives, detergents, or cleansing agents.
• NEVER use abrasive cleaners, brushes, gasoline, kerosene, glass or furniture polish, or paint
thinner to clean.
• DO NOT a�empt to repair the Massager. There are no user-serviceable parts. For service, contact
Consumer Rela�ons at the number listed in the Warranty sec�on.

TROUBLESHOOTING

Problem
Massage heads rota�ng
at reduced speed.
Device switches off
suddenly.
Device fails to start.
Jerky mo�on of massage
heads/Vibra�ons from
device.
Solu�on
The load on the massage heads is excessive. Reduce pressure
again.
and try
Device may have been in use for 15 minutes. Auto-shutoff func�on
ac�vated. Con�nue using by pressing the 'On' bu�on a�er res�ng
the unit for 15 minutes.
Over-heat protec�on func�on ac�vated. Device is switched off for
your safety. Please rest device for 15-30 minutes before restar�ng.
Check if device has been used for more than 15 minutes. If so, let
device rest for 15 minutes before con�nuing. Device may require
longer �me to cool in warmer environments.
Check if adaptor is plugged into socket.
Check if adaptor output is connected to device power inlet wire.
Excessive pressure may have been applied to the device.
Reduce pressure and try again.
8