Advertisement

Quick Links

REFRIGERATOR
-
UND1093W

Advertisement

Table of Contents
loading

Summary of Contents for UNITED UND1093W

  • Page 1 REFRIGERATOR UND1093W...
  • Page 2 Contents SAFETY WARNINGS ......................1 INSTALLTION ........................2 Location ........................2 Reversing the Door Swing ..................2 Door Space Requirements ..................3 Levelling the Unit ....................... 4 Cleaning Before Use ....................4 Before Using Your Unit ....................4 Interior Accessories ....................4 PRODUCT OVERVIEW ......................
  • Page 3 Defrosting ........................6 Cleaning the Interior and the Exterior of the Unit ............. 6 Cleaning Tips ......................6 MAINTENANCE ........................6 Changing the Internal Light ..................7 Care When Handling / Moving Your Unit ..............7 Servicing ........................7 Switching Of for Long Periods of Time ............... 7 Trouble shooting .......................
  • Page 4: Safety Warnings

    1. SAFETY WARNINGS Caution: risk of fire WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. WARNING―Do not damage the refrigerant circuit.
  • Page 5 2. INSTALLTION 2.1 Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated with an average room temperature of between 16℃ and 38℃. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
  • Page 6: Door Space Requirements

    3) Place to one side. 4) Slide the Appliance door down about 15cm and off the top hinge pin and lift away from the Appliance. 5) Remove the two screws from top bracket and replace on the otherside.You will need to first remove the plastic caps from the other side.
  • Page 7: Levelling The Unit

    Levelling the Unit To do this adjust the two levelling feet at the front of the unit. If the unit is not level, the door and magnetic seal alignments will not be covered properly. Cleaning Before Use Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using a 'Wrung-out' sponge or cloth.
  • Page 8: Product Overview

    3. PRODUCT OVERVIEW S mall door P an drain , Tray Thermos tat S teel w ire s helf Leveler , *All images in this instruc on manual are for indica on only; please refer to your individual unit for details. OPERATION 4.
  • Page 9: Maintenance

    4.3 Tips for Keeping Food in the Unit ◆ Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid bacterial transfer. Keep raw meats/fishes in a container which is large enough to collect juices and cover it properly. Place the container on the lowest shelf. ◆...
  • Page 10: Troubleshooting

    6.1 Changing the Internal Light Lamp replacement by professionals. 6.2 Care When Handling / Moving Your Unit Hold the unit around its sides or base when moving it. Under no circumstances should it be lifted by holding the edges of the top surface. 6.3 Servicing The unit should be serviced by an authorized engineer and only genuine spare parts should be used.
  • Page 11: Tips For Energy Saving

    ◆Buzz: Buzz will be generated by running compressor specially when starting up or shutting down. 8. TIPS FOR ENERGY SAVING Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, close it as soon as possible. Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance).
  • Page 12 household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased.

Table of Contents