Advertisement
Problem
EN
The appliance does not
produce any steam.
Accessoriesdonotfit
inside the compartment.
Hanger poles come loose
when I carry the steamer.
Hanger poles are not
stable.
GC670: The steamer does
not produce any steam.
Steam comes out at the
hose connection on the
steamer.
Hanger poles do not stay
in place and keep falling
down.
The stand is too high.
An excessive amount of
water drips out of the
steamer head when the
appliance is heating up.
GC660: AllLEDsflash.
Possible cause
The steamer has not
heatedupsufficiently.
The water tank is empty.
Steam has condensed in the
supply hose.
You have placed the acces-
sories into the compart-
ment in the wrong order.
The poles have not been
fastened properly.
The poles have not been
fastened properly.
The appliance is in 'keep
warm' mode.
The steamer hose is not
properly connected to the
steamer.
The clips have not been
fastened properly.
You have not adjusted the
stand to a proper height.
The water in the appliance
is dirty or has been left
inside too long.
Solution
Let the appliance heat up for approx.
30 seconds.
Refillthewatertank.
Lift the steamer head to straighten the
supply hose. This allows any condensa-
tiontoflowbackintothewatertank.
Follow the order shown on page 8.
The order is also shown inside the
compartment.
See page 5 for instructions on how to
fasten the poles.
See page 5 for instructions on how to
fasten the poles.
Press the + button to restart steaming.
Switch off the steamer. Wait until the
steamer has cooled down. Unscrew the
hose and reconnect it securely.
Fasten the clips again.
Undo the clips on the poles and adjust
the height of the stand to a comfortable
working height.
Remove all water from the water tank
and rinse it with clean water.
Send steamer to service centre
for repair.
25
Advertisement
