Table of Contents
Advertisement
USER GUIDE
Attentions:
Titan Products recommends allowing the unit to run overnight before loading with product. As warm air
rises, the temperature inside the unit tends to be slightly warmer at the top and slightly cooler at the
bottom.
When
plugged
in,
turned off during installation, simply press
press
again.
Handle Installation
Step 1 - Open the door and carefully pull the door gasket around the area where the handle is to be installed.
Step 2 - Insert each Phillips head screw through the gasket side of the door until the screw passes through the
door.
Step 3 - Align the handle with the screws and tighten the screws using a Phillips head screwdriver until the handle
is flush against the door frame.
Caution: Do not over‐tighten the screws as this may cause damage to the handle or to the stainless steel
Step 4 - Carefully press the door gasket into its original position.
Gasket
WARNING
!
Improper gasket installation will result in condensation
the
unit
will
begin
operating
under the factory default settings.
and the unit will immediately switch on. To turn the unit off,
door.
Screw
Flat Washer
Locked Washer
13
www.titan-appliances.com
If
the
unit
was
Handle
Door Frame
Advertisement
Table of Contents
