Craftsman 247.378970 Operator's Manual page 10

Attaching the Grass Catcher
1. Follow steps below to assemble the grass catcher. Make certain bag is turned
right side out before assembling (warning label will be on the outside).
a. Place bag over frame so that its black plastic side is at the bottom.
b. Slip plastic channel of grass bag over hooks on the frame. See Figure 7.
2. Follow steps below to attach grass catcher:
a. Lift rear discharge door.
b. Place grass catcher into the slots in the handle brackets as shown in
Figure 8. Let go of discharge door so that it rests on the grass catcher.
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up
and off the slots in the handle brackets. Release rear discharge door to allow it to
close rear opening of mower.
NOTE: Make sure to clean any excess grass from around the rear discharge
opening of the mower, especially between the transmission cover and
sidewall on the left hand side and along the bottom, to ensure tight fit of
bag onto mower.
ASSEMBLY
1.
b
10
a
Figure 7
b
a
b
Figure 8